Comfortbilt Pellet Stove Parts

Replacement Auger Motor & Gearbox assembly for our ComfortBilt Pellet Stoves Alpine Motor is Compatible with HP40, HP41, and HP42 model stoves.

Replacement cast burn pot for Alpine HP40 pellet stove. *Cast construction - 1.6 lbs.

36"Replacement data cable for Legacy software panels. (all models) except HP22N Used for reaching control panel placement with installed Hopper 

Set of 2 adjustable side latches. Secures the bottom Ash Pan of the ComfortBilt HP61 pellet stove.

Replacement front Door for Comfortbilt Pellet Stoves Bay Window doors will fit all HP21, HP22, HP22N and HP22i model pellet stoves.  - Comes in regular black or Stainless steel trim options. Square Window doors will fit the HP61 model pellet stove...

These replacement pellet stove feet work with all ComfortBilt pellet stoves. Pack of 4.

This kit is intended to upgrade stoves that use the ribbon data cable (manufactured before May 2019) and retrofit them to be able to use the newer electronics with the 4-pin data cable. This upgrade will include new features such as: ECO...

Replacement auger motor capacitor for all Comfortbilt model stoves

Replacement data cable for Legacy software panels. (all models) Longer cable needed for the HP22N with hopper extension

Replacement glass for the Comfortbilt HP50s Pellet Stove. To change the glass panel on the HP50 requires: 1-Remove all perimeter screws on the metal frame inside the door. 2- Remove old glass panel, be careful as it is sharp where...

Replacement Heat Shields for HP21 and HP61 models. (please select the correct stove in the options) Plate only, does NOT include nuts/bolts hardware.

Teflon (PTFE) washer that sits at the bottom of the auger bit, on top of the bottom bearing housing.   Helps keep out dust and fines from interfering with bearings.