Comfortbilt Pellet Stove Parts

4 magnets for the side panels. Makes accessing the back for maintenance very easy.

Replacement cast burn pot for Alpine HP40 pellet stove. *Cast construction - 1.6 lbs.

36"Replacement data cable for Legacy software panels. (all models) except HP22N Used for reaching control panel placement with installed Hopper 

Set of 2 adjustable side latches. Secures the bottom Ash Pan of the ComfortBilt HP61 pellet stove.

These replacement pellet stove feet work with all ComfortBilt pellet stoves. Pack of 4.

Replacement auger motor capacitor for all Comfortbilt model stoves

Replacement data cable for Legacy software panels. (all models) Longer cable needed for the HP22N with hopper extension

Replacement glass for the Comfortbilt HP50s Pellet Stove. To change the glass panel on the HP50 requires: 1-Remove all perimeter screws on the metal frame inside the door. 2- Remove old glass panel, be careful as it is sharp where...

Replacement Heat Shields for HP21 and HP61 models. (please select the correct stove in the options) Plate only, does NOT include nuts/bolts hardware.

Teflon (PTFE) washer that sits at the bottom of the auger bit, on top of the bottom bearing housing.   Helps keep out dust and fines from interfering with bearings.

Spring Cleaning Kit - comes with cleaning brushes and a gasket replacement set. Gasket set comes with 2 large circular combustion fan gaskets, and 4 rectangular ash-trap chamber gaskets. Brushes 2pk:  Full Brush Length: 30” - Without...

Replacement wire that attaches from the 2-pin jumper at the Motherboard to the Vacuum pressure sensor or Proof of Fire Sensor Switches.